gCreate gMax 2 Getting Started page 7

gMax Initial Run (Required)
1. You must run the supplied gcode file to test your gMax
printer a er transport.
2. Slide the SD card (upside-down) into the le side
of the LCD screen.
3. On the LCD screen, the bo om line should now say
Inserted". If not, try removing the SD card and reinser ng it
and make sure the "lock" is in the off posi on on the side of the card.
4. Push in the LCD screen knob (this is your accept bu on) and scroll down to
and push in the knob again.
5. Under "gCreate Files" Select
ons on the LCD screen and click the knob when prompted between tests. The test file will
perform several func ons:
• X, Y, Z Axis test (slow moves, then fast moves)
• Bed Probe test (center and full grid)
• Extrusion test (with heat)
• Fan test then cooldown
"Card
"gMax Ini al Setup". Click to start test, then follow the instruc-
"Print from
Note
The gMax "Initial Run Test File"
should take about 15 minutes
to complete and will wait for you to
"Click to proceed" between tests.
If the printer fails during any of
these tests or the bed probe
doesnt drop/raise contact support.
SD"
Pg 6