Data Editing
•
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar code data) and/
or as a suffix (in a position following the bar code data) as indicated in
Figure 4-2. Prefix and Suffix Positions
Example: Setting a Prefix
In this example, we'll set a prefix for all symbologies.
1. Determine which ASCII character(s) are to be added to scanned bar code data. In this
2. Scan the START bar code.
3. Scan the SET PREFIX bar code.
4. Reference the
5. Scan the END bar code to exit Programming Mode.
NOTE
6. The resulting message string would appear as follows:
4-2
Enter prefixes and suffixes in the order in which you want them to appear on the output.
Prefix
Label ID
example, we'll add a dollar sign ('$') as a prefix.
ASCII Chart
assigned to the desired character. The corresponding hex number for the '$' character is
24. To enter this selection code, scan the '2' and '4' bar codes from
.
Numeric Pad
If less than the expected string of 20 characters are
selected, scan the END bar code twice to accept the
selections and exit Programming Mode.
Scanned bar code data:12345
Resulting message string output: $12345
AIM ID
Bar Code Data
00 - 20 Characters (ASCII)
AND
OR
on the inside back cover of this manual, to find the hex value
.
Figure 4-2
OR...
Label ID
Suffix
Appendix C, Alpha-
®
Magellan
1400i