Scanning Features; Aiming Pointer; Targeted Scanning Mode - Datalogic MAGELLAN 1400I Product Reference Manual

General Features

Scanning Features

Aiming Pointer

This feature enables/disables the Aiming Pointer for all symbologies.
START / END
Enable always on

Targeted Scanning Mode

Upon pressing the button, the scanner will project an aiming pattern to assist in centering over
the bar code. Scanning then takes place as soon as the button is released.
Configuration options for Targeted Scanning Mode are:
•
•
2-12
PROGRAMMING BAR CODES
When add-ons are enabled and a bar code is being read while in Targeted
Mode, position the pointer at or near the end of the base label to ensure
the scanner will read both the base and add-on label.
Targeted Scanning Mode will read bar codes in any orientation.
NOTE
The scanner will return to full pattern Omni-directional Mode after either
of the following has ocurred:
- Good Read +
-
Target Mode: Active Time
Target Mode: Active Time
Target Mode: Linger Time
has elapsed.
Target Mode: Linger Time
+
Target Mode: Linger Time
Disable
DEFAULT
has elapsed.
®
Magellan 1400i