Typical Layouts; Point-To-Point - Datalogic DS6400 Reference Manual

2
If using the "45° Skew" installation, the scanner reading performance is
not guaranteed to match that measured for the standard installation with
Skew angle between 10° - 20° (see reading diagrams in par. 4.4.1).
ATTENTION
The ST-210 mounting bracket is an accessor
model available in the US-60 kit (890001020).
NOTE

2.7 TYPICAL LAYOUTS

The DS6400 scanners can be connected in a variety of layouts depending on the number of
scanners used and the required complexity of the reading station. These layouts range from
Single Stand Alone to Complex Lonworks Networks.
S everal power supplies are available to power the reading stations. Photoelectric sensors
used as code presence sensors and optical encoders to signal conveyor speed are also
available accessories.
The following typical layouts refer to the system hardware configurations, but they also
require the correct setup of the software configuration paramete
T he accessories and cables indicated in the following figures are Datalogic products. We
suggest their use to guarantee

2.7.1 Point-to-Point

Using a Point-to-Point layout, the data is transmitted on the Main interface as well as on the
Auxiliary inte rface. The Main interface can be selected for RS232 or RS485 full-duplex
communications.
Two different layouts are available according to the DS6400 reader model used for the
connection.
36
the correct system functioning.
y of the DS6400 standard
rs (see par. 3.2 for details).
DS6400