Directed Electronics PYTHON 1090 Installation Manual page 43

You can advance from one function step to another by releasing the Valet/Program switch and tapping it
to advance function steps and then HOLDING it. For instance: You have programmed function step 2 (Arm
Only) and you want to program function step 8 (Channel 6). Release the Valet/Program switch. Press it 6
times and release it to advance from function step 2 to 8. Now, press and HOLD the Valet/Program switch.
The LED will flash 8 times and the siren will chirp 8 times. As before, do not release it.
Learn Routine will be exited if:
■ Door is closed.
■ Ignition is turned off.
■ Program switch is pressed too many times.
■ More than 15 seconds between steps.
© 2006 Directed Electronics—all rights reserved
Transmit. While HOLDING the Valet/Program switch, press the
4.
button on the remote control that you would like to control the
selected function. The unit will chirp to confirm that the code has
been successfully programmed.
It is not possible to teach a remote control button to the system
more than once.
Release. Once the code is learned, the Valet/Program switch can
5.
be released.
43