Nice MIGHTY MULE MMS100 Installation Manual

Wireless Connectivity System
NOTE: Your Mighty Mule gate operator should be installed prior to setting up the MMS100 Wireless Connectivity System.
NOTE: MMS100 requires a 2.4 GHz WiFi Frequency. Most routers support this feature. Please consult your router's manual or
manufacturer for confirmation.
AT THE GATE - INSTALLING THE RADIO MODULE
Prior to any assembly of the MMS100, ensure that the Mighty Mule gate operator is turned OFF and disconnected from its power

source.

If required, punch out the access hole for the Auxiliary Antenna.

Align the connectors, then plug in the small radio module into the operator control board.

Guide the radio module antenna cable through the Auxiliary Antenna hole, then twist and tighten the antenna pointing upward.

Power on the gate operator.

Auxiliary
Antenna
Access
(Punch Out)
Wi-Fi ROUTER - Setting Up and Provisioning The Bridge
1. Install/locate the bridge near your Wi-Fi router.
2. Connect the Antenna.
3. Plug in the MMS100 receiver (only one gate operator
can be connected to your Bridge).
Nice G.O. Homeowner Smartphone App Installation
Download, Register and Activate Application
Use a smartphone to visit the app store to download and install the Nice G.O. application. On initial
use, you'll be asked to register and create your account. Once completed, sign in with the new
account information (QR Code displayed to the right).
Connect the MMS100 to the Nice G.O. app
Stand near the Wi-Fi bridge. On your mobile device in the Nice G.O. app, tap the plus sign at the top
right of screen to Connect Your Device. Follow directions in the app to Connect Your Device.
Installation Manual

MMS100
PAIR
RESET
Scan to download
the app.
