Step 2 - Mounting And Positioning The System - Datalogic Reader Matrix-1000 Reference Manual

1
When connected to a C-BOX 3x0/4x0, Matrix-1000™ can only
communicate through its Auxiliary Interface. The Matrix-1000™ 9-pin
Auxiliary port connector cannot be used for communication (i.e.
configuration through VisiSet™). To configure Matrix-1000™ through the 9-
CAUTION
pin connector inside the C-BOX 3x0/4x0, the C-BOX 3x0/4x0 must first be
configured. See the relative C-BOX Installation Manual for details.
STEP 2 – MOUNTING AND POSITIONING THE SYSTEM
1. To mount the Matrix-1000™, use the mounting bracket to obtain the most suitable
position for the reader as shown in the figures below.
2. When mounting the Matrix-1000™ take into consideration these three ideal label position
angles: Pitch or Skew 10° to 20° and Tilt 0°, although the reader can read a code at any Tilt
angle.
Minimize
3. Refer to the Reading Features in chp. 7 to determine the distance your reader should be
positioned at.
2
Figure 2 - Positioning with Mounting Bracket
Assure at least 10°
Figure 3 – Pitch, Skew and Tilt Angles
Matrix-1000™ Reference Manual
Minimize