Assembly & Setup - Grizzly G0451 Instruction Manual

assembly & Setup
Before shipping, the sliding table was set at the
factory to be even with the main table and parallel
with the blade.
To assemble the sliding table saw:
1. install the end handle, as shown in figure
23.
figure 23. sliding table end handle.
2.
rotate the table lock 180˚ to unlock the slid-
ing table. the sliding table is locked in place
when the table lock is in the position shown
in figure 23.
3. install the push handle into the table, as
shown in figure 24, with a 12mm flat washer
and M12-1.75 t-nut.
12mm Flat Washer
push
handle
figure 24. sliding table push handle installed.
-24-
table lock
end handle
M12-1.75 t-nut
4.
thread two M6-1 x 12 set screws into the
small holes in the small extension table.
Make sure the set screws do not stick out
from the mating surface.
5.
loosely attach the small extension table with
two M10-1.5 x 20 cap screws, two 10mm
lock washers, and two 10mm flat washers as
shown in figure 25. note: The cap screws
will be tightened during a later step.
figure 25. small extension table attached.
6. loosely attach the large extension table with
four M10-1.5 x 20 cap screws, four 10mm
lock washers, and four 10mm flat washers,
as shown in figure 26, and thread in four
M6-1 x 12 set screws. note: The cap screws
will be tightened during a later step.
figure 26. large extension table attached.
g0451 14" sliding table saw