Lubrication - Grizzly G0451 Instruction Manual

lubrication

the bearings are sealed and pre-lubricated and
require no lubrication during their usable life.
however, your saw components will operate
at their best if the bearing surfaces are kept
clean—this is especially important for the trun-
nion bearings.
lubricate the areas indicated below every 6-12
months, depending on frequency of use.
1. blade angling trunnions. these should be
lubricated with 6 or 7 drops of light machine
oil (see figure 85).
figure 85. Blade angling trunnions.
2. Sliding table ways. spray or wipe on a light
machine oil such as Wd-40
of the steel rods (see figure 86).
figure 86. sliding table ways.
g0451 14" sliding table saw
Blade Angling
trunnion
the entire length
®
3. Scoring blade worm gears. lubricate with
an automotive wheel bearing grease.
Blade height
slide
scoring Blade
Worm gears
Blade tilt
Worm gear
figure 87. gear lubrication.
4. blade height linkage. lubricate with an
automotive wheel bearing grease.
5. blade height bearing (hidden behind the
motor in figure 87). lubricate with an auto-
motive wheel bearing grease in a grease
gun.
6. blade tilt worm gear. lubricate with an
automotive wheel bearing grease.
7. blade height slide. lubricate with an auto-
motive wheel bearing grease.
Blade height
linkage
-47-