Table of Contents
Advertisement
Test Run
Test run the machine before installing the chisel
to isolate any problems that may occur.
1.
Plug the mortising machine into the power
supply.
2.
Turn the mortising machine ON.
Note: Make sure your finger is poised over
the switch, just in case there is a problem.
The mortising machine should run smoothly, with
little or no vibration or rubbing noises. Strange or
unnatural noises should be investigated and cor-
rected before operating the machine further. See
Page 26 for troubleshooting instructions.
If you cannot easily locate the source of an
unusual noise or vibration, contact our Service
Department at (570) 546-9663 for help.
G0448 Mortising Machine
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum results.
Keep this in mind as you start to use your new
mortising machine.
Step-by-step instructions for these adjust-
ments can be found in SECTION 7: SERVICE.
1.
Gib Adjustments (Page 27).
2.
Head Tilt Calibration (Page 28).
3.
Fence Calibration (Page 29).
-17-
Advertisement
Table of Contents
