Roxell – 040 – 0724 Dos7 – Table of contents TABLE OF CONTENTS Disclaimer General information Instructions for the user ........................I-1 General safety rules ............................... I-1 General introduction ..............................I-2 Directions for operating the system ..........................I-2 Determining the volume in the dispenser ........................I-3 Maintenance instructions ..............................
The original, authoritative version of this manual is the English version produced by ROXELL BV Subsequent changes to any manual made by any third party have not been reviewed nor authenticated by Roxell. Such changes may include, but are not limited to, translation into languages other than English, and additions to or deletions from the original content.
Roxell’s most current use and maintenance manuals; use of cleansing agents and disinfectants in violation with the instructions received from the suppliers;...
Page 5
In the European Union If you have used the product for commercial purposes and you want to dispose of it, contact Roxell, who will give you information about the return of the product. It is possible that you will have to pay a disposal charge for the return and recycling.
Page 6
Dos7 – General information Roxell – 040 – 0724 LOTOTO = Lock Out - Tag Out - Try Out Before you begin: Everyone needs his own lock and tag (label), which can’t be removed by other persons. Inform all the persons who are influenced by the procedure.
Page 7
Roxell – 040 – 0724 Dos7 – General information Information about the residual risks - used safety signs There are three levels of danger, which you can recognize from the following signal words: • DANGER • WARNING CAUTION • The nature and source of the imminent danger and possible consequences of not obeying warnings is stated here!
Roxell – 040 – 0724 Dos7 – Instructions for the user Instructions for the user General safety rules Dos7 nr: 040 Automatic feeding system for sow feeding DANGER: Carefully read the instructions before you use the system. • Always turn off the electricity supply with the main switch, before you do any repair or maintenance work.
The feed drops at any given time from all the dispensers into the troughs. Directions for operating the system Transport system Depending on the used transport system, you choose the correct top of the Dos7 dispenser for the different tube sizes: Ø56, Ø60, Ø75, Ø90. Use of the system When you lower up the dump ball, the dispensers open and the feeding starts.
Roxell – 040 – 0724 Dos7 – Instructions for the user Determining the volume in the dispenser Determining the volume in the Example dispenser Weigh an empty measuring jug: T T = 50 g L = 1 l Fill the measuring jug with 1 l feed: M = 700 g L [l].
Dos7 – Instructions for the user Roxell – 040 – 0724 Maintenance instructions DANGER: Turn off the main switch first. Ensure you use personal protective equipment (protective gloves, anti-slip safety shoes, safety glasses, dust mask...). ATTENTION: Actions on a grey background must be done by a technically trained person.
Roxell-040-0724 Dos7- Instructions for the user House Chart Before using the Dos7 dispenser Calibrate the dispenser with the feed that you will use. Using the control dispenser Ensure that there are always sows in the compartment when using a control dispenser.
Page 14
Roxell-040-0724 Dos7- Instructions for the user Calibration of the feed For an exact feed dosage, it is recommended to calibrate the scale with the feed you are using. NOTE: The indication of the volume on the dispenser for mash, crumble and pellets is a volume scale. The weight of the feed associated with a certain setting on the dispenser will vary with the specific weight of the feed you are using.
Tel: + 32 50 72 91 72 Fax: + 32 50 71 67 21 “This part may only be filled out if all built-in subparts are delivered by Roxell” Verklaart geheel onder eigen verantwoordelijkheid dat het product: EG-verklaring van overeenstemming (Richtlijn 2006/42/EG, Bijlage II.1.A)
Page 16
Supply of Machinery (Safety) Regulations 2008 Manufacturer: Roxell BV, Industrielaan 13, 9990 Maldegem “This part may only be filled out if all built-in subparts are delivered by Roxell” Tel: +32 50 72 91 72 Fax: +32 50 71 67 21...
Page 18
ROXELL USA Inc. - 720 Industrial Park Road, Anderson MO 64831 (USA) Tel. +1 417 845 6065 - info.usa@roxell.com - www.roxell.com ROXELL Malaysia - No. 49, Jalan Permata 2/KS9, Taman Perindustrian Air Hitam, 41200 Klang, Selangor (Malaysia) Tel. +60 3 3123 1767 - info.malaysia@roxell.com - www.roxell.com...
Need help?
Do you have a question about the Dos7 and is the answer not in the manual?
Questions and answers