Read this manual carefully before use, and retain it for future reference. Product Overview Lid Release Button Dust Cover Water Dispensing Button Seal Ring Handle Kettle Body Anti-slip Silicone Pad...
How to Use Note: Make sure to clean the kettle thoroughly before first use. Opening the lid: Pinch the lid release button inward with two fingers until the dust cover pops up, and then lift the lid up. Lower Edge Line of the Lid Adding water: As shown in the Approx.
Hot Insulation Performance Test Conditions: Open the lid and leave the empty kettle for 30 minutes in an indoor environment with a temperature of 20℃ ± 5℃. Then add 100℃ water up to the lower edge line of the lid, and wait until the water temperature in the kettle drops to 95℃...
Page 5
When adding hot beverages, make sure that the maximum water level must be 1 cm lower than the lower edge line of the lid to avoid over ow which may cause burns. Do not use sharp and hard objects to scrub the kettle. Do not clean with bleach, abrasive powder, stain- removing or chlorinated detergents to prevent rust or corrosion on the kettle.
06Cr19Ni10 Steel 316L Austenitic stainless Inner wall steel 022Cr17Ni12Mo2 Manufactured for: Xiaomi Communications Co., Ltd. Manufactured by: Shenzhen Pinlo Innovation Industrial Co., Ltd. (a Mi Ecosystem company) Address: Suite 408-03B, Building 2, Block M-10, Ma Que Ling Industrial Zone, Ma Ling Community, Yue Hai Street, Nanshan District, Shenzhen, China For further information, please go to www.mi.com...
Products which were not duly imported and/or were not duly manufactured by Xiaomi and/or were not duly acquired from Xiaomi or a Xiaomi’s official seller are not covered by the present warranties. As per applicable law you may benefit from warranties from the non-official retailer who sold the product.
Need help?
Do you have a question about the MI XMBWH01PL and is the answer not in the manual?
Questions and answers