Changing Batteries - Gateway Solo 9300 User Manual

Changing batteries

Batteries can be "warm-swapped." This means that you can change batteries
while in Standby mode.
To replace the battery:
1 If your notebook is on, save all work and press F
into Standby mode.
2 Turn your notebook over, then slide the battery release latch and lift the
battery out of the bay.
3 Place a recharged battery into the bay and press down until it snaps into
place.
4 Open the notebook and press the power button.
Warning
96
Managing Power
Danger of explosion if battery is incorrectly replaced.
Replace only with the Gateway Solo 9300 Li-Ion battery.
Discard used batteries according to the manufacturer's
instructions.
The battery used in this device may present a fire or
chemical burn hazard if mishandled. Do not disassemble,
heat above 212°F (100°C), or incinerate. Dispose of used
battery promptly. Keep away from children.
+ . The notebook goes
F4
N