Franke FDW 908 IB XS Instructions For Use And Installation

Hide thumbs Also See for FDW 908 IB XS:

User manual (157 pages)

Instructions for use and installation (140 pages)

Instructions for use and installation (88 pages)

Table Of Contents

Quick Links

Download this manual

Instructions for use and installation

Cooker Hood

FDW 908 IB XS

FDW 908 IB WH

Table of Contents

Need help?

Do you have a question about the FDW 908 IB XS and is the answer not in the manual?

Questions and answers

Summary of Contents for Franke FDW 908 IB XS

Page 1 Instructions for use and installation Cooker Hood FDW 908 IB XS FDW 908 IB WH...
Page 2: Table Of Contents
INDEX SAFETY INFORMATION ................................. 3 CHARACTERISTICS ................................6 INSTALLATION ..................................8 USE ....................................18 CARE AND CLEANING ..............................20...
Page 3: Safety Information
SAFETY INFORMATION For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance. The wire connection has to be done by specialized technician.
Page 4 • If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood.
Page 5 • The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Accessible parts may become hot when used with cooking appliances. •...
Page 6: Characteristics
CHARACTERISTICS Components Ref. Q.ty Product Components Hood Canopy complete with: Controls, Light, Filters Motor unit Electric unit Front Frame Directional Air Outlet grille Reducer Flange ø 150-120 mm Damper Ref. Q.ty Installation Components Splashback Fixing Bracket Hob Fixing Bracket Side Bracket Screws 3.5 x 9.5 Screws M4 x 8 Screws 4 x 15...
Page 7 Dimensions 880mm 794mm 802mm...
Page 8: Installation
INSTALLATION This Hood is set up to be fitted inside the kitchen unit in: • Ducting version: Evacuation to the outside. • Recirculation version: Internal recirculation. Sequence of operations - Installation • Drilling the Support Surface and Fitting the Hood •...
Page 9 Inserting the Hood Canopy into the support surface from below • The Hood is built ready for front installation of the Motor Unit. • If the kitchen unit is arranged differently and the Motor Unit has to be fitted on the back, the Plug already fitted on the back of the Hood Canopy must be removed and replaced at the front, and the Cable with cable raceway for connection of the Motor must also be repositioned using the slot provided on each side (A).
Page 10 Inserting the Hood Canopy into the support surface from above • Insert the Brackets 7.2, as indicated in the figure, into the slots provided and fix them with the screws 12a provided. • The Hood is built ready for front installation of the Motor Unit.
Page 11 Fixing the Lower Brackets • Screw the brackets 7.1 to the front of the Hood Canopy using the screws 12a provided. • Before tightening the Brackets completely, make all the adjustments to allow them to rest on the lower base of the worktop to avoid deformation of the upper brackets 7.2 as shown in the figure.
Page 12 Fixing the Squaring Brackets • Screw the brackets 7.3 to the Hood Canopy using the screws 12b provided, without tightening completely. • Using the screws 12c provided, fasten the other part of the brackets 7.3 either to the side walls of the unit or to the lower part of the cooker top. •...
Page 13 Fixing the Motor Unit • Installation of the Motor Unit (1) at the front or rear must be decided according to the position of the Kitchen unit, making sure that the plug is properly positioned. • Subsequently, according to where the air outlet opening has been created on the unit, the Motor Unit can be turned by 90°...
Page 14 Fixing the Electric Unit • Connect the Electric cables that come out of the lower right hand part of the Hood Canopy to the Connectors on the Electric unit. • Each cable connector has a corresponding connector on the Electric Unit, so take care not to make mistakes when connecting up.
Page 15: Electrical Connection
Connections DUCTED VERSION AIR EXHAUST SYSTEM ø 150 When installing the ducted version, connect the hood to the ø 120 chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. To install a ø...
Page 16 Fitting the Front element • Lift the mobile hood canopy (see paragraph on Use) by just a few centimetres. • To stop movement, simply press down on the mobile canopy as it lifts up. Warning: Never block the Warning..: sliding door when it is opening Handle or closing, except during the with care...
Page 17 Surround Suction Panel • Open the Hood Door (see USE). • Remove the 2 strips of adhesive tape fastening the panel during transport.
Page 18: Use
Control panel Button Function LED button The button only works when the door is open. Press Briefly = Turns the Lights On/Off at maximum intensity. Press and hold for 2 Seconds = Turns the Courtesy lights On/Off. Door Open or Closed After 100 hours in operation the Drop symbol is Reset Press briefly(Motor Off) = performs a...
Page 19: Remote Control (Optional)
REMOTE CONTROL (OPTIONAL) This appliance can be controlled using a remote control. Remote control panel Warning..: The remote control receiver is deactivated when first supplied. To activate it, see the paragraph Use. Door Closed: Opens the door, turns the motor on at speed one and turns the lights on at maximum intensity.
Page 20: Care And Cleaning
CARE AND CLEANING Cleaning the Comfort Panels • Open the Comfort Panel by pulling it at the top. • Disconnect the panel from the hood canopy. • The comfort panel must never be washed in the dishwasher. • Clean the outside with a damp cloth and neutral detergent. •...
Page 21: Lighting Unit
Activated Charcoal Filter (Recirculation Version) Can be washed in the dishwasher. It must be washed when button “C” lights up or at least once every 4 months, or more frequently if use is particularly intense. Guaranteed to operate after washing for up to a maximum of 5 times before requiring replacement. The Alarm signal, if it has been activated, only appears when the Suction motor is turned on.
Page 24 Franke S.p.a. Via Pignolini, 2 37019 Peschiera del Garda (VR) www.franke.it Franke Sistemas de Cozinhas do Brasil Dona Francisca, 8.300. Bloco N – Sala 49 – Condomínio Perini Business Park Distrito Industrial - 89219-600 Joinville - SC - Brasil Fone +55 47 3431 0500...

This manual is also suitable for:

Fdw 908 ib wh