Technical Information; Installation Considerations - Hans Grohe AXOR MyEdition 47432 1 Series Installation/User Instructions/Warranty

T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate
spout
handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTA LL AT I O N CO N SID E R ATI ONS
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
This trim is for use with rough valve 13444181
(not included).
⁄ This unit is not anti-scald. In Massachusetts, or if re-
quired by local plumbing code, install an approved
water temperature limiting device conforming to ASSE
1070 (not available from Hansgrohe).
⁄ To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher than
120°F (49°C). In Massachusetts, the maximum out-
put temperature can be no higher than 112°F (44°C).
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
5.8 GPM (22 L/min)
Max. 1.75 GPM (6.6 L/min)
E N G L I S H
⁄ The mounting surface must be finished and made
watertight before installation of this trim kit.
⁄ Protection against backflow is provided by a check
valve in the handshower hose and by an automati-
cally resetting diverter.
⁄ This handshower is for use with automatic compensat-
ing valves rated at 1.3 GPM (4.9 L/min)or less.
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary
to request warranty parts.