Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Defy Maximaid 720
Summary of Contents for Defy Maximaid 720
- Page 1 DAW 319 DAW 320 YOU CAN RELY ON DEFY www.defy.co.za...
- Page 2 1 Warnings Safety instructions • This appliance must be connected to General Safety an earthed outlet protected by a fuse of • Never place your machine on a carpet suitable capacity. covered floor. Otherwise, lack of airflow • The supply and draining hoses must from below of your machine may cause always be securely fastened and remain in electrical parts to overheat. This may cause an undamaged state. problems with your washing machine. • Fit the draining hose to a washbasin or • If the power cable or mains plug is bathtub securely before starting up your damaged you must call Authorized Service machine. There may be a risk of being for repair. scalded due to high washing temperatures! • Fit the drain hose into the discharge • Never open the loading door or remove the housing securely to prevent any water filter while there is still water in the drum. leakage and to allow machine to take in • Unplug the machine when it is not in use. and discharge water as required. It is very • Never wash down the appliance with a important that the water intake and drain water hose! There is the risk of electric hoses are not folded, squeezed, or broken...
- Page 3 2 Installation • If you are going to use your double water- inlet machine as a single (cold) water-inlet Removing packaging unit, you must install the stopper*, supplied reinforcement with your machine to the hot water valve. Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Opening the transportation locks Transportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged! • If you want to use both water inlets of the 1. Loosen all the bolts with a spanner until product, you can connect the hot water they rotate freely (“C”) hose after removing the stopper and 2. Remove transportation safety bolts by gasket group from the hot water valve. turning them gently. * Applies for the products supplied with a blind 3. Fit the covers (supplied in the bag with the stopper group. Operation Manual) into the holes on the • Models with a single water inlet should not rear panel. (“P”) be connected to the hot water tap.
-
Page 4: Initial Preparations For Washing
Electrical connection can be opened when the symbol fades out. Connect the machine to an earthed outlet Detergents and softeners protected by a fuse of suitable capacity. Important: Detergent Drawer • Connection should comply with national The detergent drawer is composed of three regulations. compartments: • The voltage and the allowed fuse The detergent dispenser may be in two protection are specified in the section different types according to the model of your “Technical Specifications”. machine. • The specified voltage must be equal to – (I) for prewash your mains voltage. – (II) for main wash • Connection via extension cords or multi- - (III) siphon plugs should not be made. A damaged power cable must be replaced – ( ) for softener by a qualified electrician. The appliance must not be operated unless it is repaired! There is the risk of electric shock! 3 Initial preparations for washing Preparing clothes for washing Detergent, softener and other cleaning... -
Page 5: Selecting A Program And Operating Your Machine
4 Selecting a Program and Operating Your Machine Control panel 1 - Spin Speed Adjustment Button 7 - Child-proof Lock Indicator* 2 - Time Delaying Button 8 - Program Follow-up Indicators 3 - Auxiliary Function Keys 9 - On/Off Button 4 - Start/Pause/Cancel Button 5 - Program Selection Knob * According to your machine’s model 6 - Display Turning the machine on •Cottons You can wash your durable clothes with this Plug in your machine. Turn the tap on... - Page 6 desired spin sped and press “Start/Pause/ Cancel” button. Your machine drains the water Additional programs after spinning at the set spin speed. For special cases, there are also extra If you only want to drain the water without programs available: spinning your laundry, select “Spin and Pump” Additional programs may differ according program, and then select no spin function to the model of your machine. with spin speed selection button. Press “Start/ • Delicates Pause/Cancel” button. You can wash your delicate clothes on this You should use a lower spin speed for program. It has more sensitive washing delicate laundries. movements and does not make intermediate spinning compared to “Synthetic” program. Spin Speed selection • Daily Whenever a new program is selected, the You can use this program to wash cottons maximum spin speed of the selected program and synthetics together. There is no need to is displayed on the spin speed indicator. sort them. To decrease the spin speed, press the “Spin” • Eco Synthetics button. Spin speed decreases gradually. Then, This program is suitable for clothes that rinse hold and no spin options are shown are normally worn for a short time such as respectively.
- Page 7 Program and consumption table Programme • • • • • • Cottons 2.72 • • • • • • Cottons 60** 1.33 • • • • • • Cottons 0.78 • Active 0.84 • • • Intensive 1.40 • • •...
- Page 8 Auxiliary functions from the values in the consumption table subject to the changes in the water pressure, Auxiliary Function Selection Buttons water hardness and temperature, ambient Select the required auxiliary functions before temperature, type and amount of laundry, starting the program. auxiliary functions selected, and changes in Some combinations cannot be selected the supply voltage. together. (Ex.: Pre-wash and Quick Wash. Warning signal on the selected auxiliary Time delay function will light up. With the “Time delay” function you can delay the program start up to 24 hours. Time delay Auxiliary function selection can be set with steps of one hour for the first If an auxiliary function that should not be three hours and with steps of three hours for selected together with a previously selected the remainder (1, 2, 3, 6, 9, …24). function is chosen, the first selected function will be cancelled and the last auxiliary function 1. Press “Time Delay” button to adjust the selection will remain active. desired time. (Ex.: If you want to select pre-wash first and 2. Press “Start/Pause/Cancel” button. The then quick wash, pre-wash will be cancelled time delay will start to count down. and quick wash will remain active. More laundry may be loaded during the Auxiliary function that is not compatible time delay period.
- Page 9 activated due to an excessive unbalanced 5 Maintenance and cleaning distribution of laundry in the machine. Detergent Drawer Remove any powder residue buildup in the Changing the selections after the drawer. To do this; program has started 1. Press the dotted point on the siphon in the Turning the program knob while the program softener compartment and pull towards is in a normal flow will not change the you until the compartment is removed from program. the machine. Switching the machine to standby mode Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be opened if the water level is suitable. Laundry may be added / taken out by opening the If more than a normal amount of water door.
- Page 10 Draining any remaining water and hose. Drain the water off into the container cleaning the pump filter by pulling out the plug at the end of the hose. If the amount of water to be drained Your product is equipped with a filter system off is greater than the volume of the which ensures a cleaner water discharge that container, replace the plug, pour the water extends pump life by preventing solid items out, then resume the draining process. such as buttons, coins and fabric fibers from • After draining process is completed, clogging the pump propeller during discharge replace the plug into the end of the hose of the washing water. and fit the hose back into its place. • If your machine fails to drain the water, If your product is not supplied with an the pump filter may be clogged. You may emergency drain hose, do the following as have to clean it every 2 years or whenever shown in the figure below: it is plugged. Water must be drained off to clean the pump filter. In addition, water may have to be drained off completely in the following cases: • before transporting the machine (e.g. when moving house) • when there is the danger of frost In order to clean the dirty filter and discharge the water;...
-
Page 11: Solution Suggestions For Problems
6 Solution suggestions for problems Problem Cause Explanation / Suggestion Machine may have switched to self Program cannot Reset your machine by pressing “Start/Pause/ protection mode due to be started or Cancel” button for 3 seconds. (see, Canceling an infrastructure problem selected. a Program) (such as line voltage, water pressure, etc.). Be sure the seals of the water inlet hoses are There is water There might be problems securely fitted. coming from with hoses or the pump Tightly attach the drain hose to the tap. the bottom of filter. Make sure that the pump filter is completely the machine. closed. Machine stopped Machine can stop It will resume operating when the voltage is shortly after temporarily due to low back to the normal level. -
Page 12: Specifications
7 Specifications Models DAW 319 DAW 320 Maximum dry laundry capacity (kg) Height (cm) Width (cm) Depth (cm) Net Weight (kg) Electricity (V/Hz.) 230 V / 50Hz 230 V / 50Hz Total Current (A) Total Power (W) 2200 2200 Spinning cycle (rpm max.) 1200 1200 Specifications of this appliance may change without notice to improve the quality of the product. Figures in this manual are schematic and may not match your product exactly. Values stated on the machine labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant standards. Depending on operational and environmental conditions of the appliance, values may vary. This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. We thank you doing your part to protect the environment. 12 - EN... -
Page 13: Service Centres
Service Centres If you have followed the instructions and still have a problem, contact the nearest Defy Service Centre. They will be able to advise you on any aspect of the product or send a qualified technician to repair it.... -
Page 14: Warranty
This certificate is issued by DEFY APPLIANCES (PTY) LIMITED, manufacturers and distributors of Defy, Ocean and Franke products, hereinafter the Company, to the original purchaser only, of the appliance described on the certificate and shall constitute the only warranty given in respect of this appliance.
Need help?
Do you have a question about the Maximaid 720 and is the answer not in the manual?
Questions and answers
I at a store to buying screws my washing machine Defy maximaid 720 I need the size of the 2 x screw that open the top of the washing machine