Gateway 310 S User Manual page 180

Chapter 11: Upgrading Your Computer
3
Lift the drive release latch up and slide the hard drive out of the hard drive
bay.
4
Set the jumpers on the drive. See the drive documentation for further
instructions.
5
Slide the new drive in the drive bay. Push firmly until the drive release
latch locks the hard drive into place.
6
Reconnect the drive cables using your notes from
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side closest to the power supply connection).
See the drive documentation for further instructions.
7
Replace the side panel following the instructions in
panel" on page
172
166.
www.gateway.com
Step 2. The red-striped
"Replacing the side