Settings Menu - GE Profile DPVH890EJ Owner's Manual And Installation Instructions

Demand Response.
Model DPVH891 is compatible with the GE Demand Response
(DR) module which can be purchased separately. Contact your
local utility or visit www.GEAppliances.com/demand_response
to see if your area is using DR technology.
The following demand response features are available as part
of a pilot test program with the local utility company to help
consumers reduce peak electricity usage in the home.
Installation
The preferred location for the module installation is on top
of the clothes dryer.
Details on how to connect the cables to the module are
in the instructions that come with the module.
Wait 5 minutes; then press the Settings button. Scroll and
look for the energy management screen as seen below.
This screen means the module is attached correctly and
you can begin to use your DR-enabled appliance following
the instructions below.
If the Energy Management Screen is not available, refer to
the DR module troubleshooting guide.
Quick Guide
There are 4 power levels available: Critical, High, Medium and
Low. On the Medium and Low levels, the unit runs as normal.
The following steps show how the unit reacts during startup
at Critical and High power levels.
Option 1 (Delay Eco)
During startups at Critical and High levels, the unit will delay
starting until the level becomes Medium or Low. Press the
START/PAUSE button.
Option 2 (Override Delay Eco)
To start the unit when Delay Eco is shown, press the DELAY
START button to turn the delay off. Then press START/PAUSE
to begin the cycle.
(on some models)
D R D S S
RYER ACK ELAY TART ETTINGS

Settings Menu

Press SETTINGS; then select Energy Management.
Delay Eco Override
If you are starting a cycle in a Critical or High utility rate, this
option allows the unit to automatically run on an Eco Cycle. This
setting will operate with less energy than normal cycles. Default
setting is YES.
Auto-Extend Delays
If a timed delay is selected, this option allows for the scheduled
start to extend if the utility rate is Critical or High at the
scheduled start. The default setting will automatically extend
these cycles.
Timed Dry Eco Option
If the unit is running in Timed Dry Mode and the utility rate
switches to Critical or High, the unit will conserve energy by
decreasing heat if YES (default) is selected. If NO is selected, the
unit will operate normally.
NOTE: When YES (default) is selected, your load may be damp
at the end of the cycle.
In order for the demand response features on the appliance to
work, additional equipment is required to be installed to interface
with the local utility. Such equipment may be sold separately
and/or is available through your utility as part of the pilot test
program. Check with your utility company to see if a pilot test
program is available in your area and for full details.
PLEASE NOTE: At the conclusion of the pilot test program or if
you move to an area where the program is not available, the
demand response features cannot be activated and utilized on
the appliance. The appliance will function as normal after the
demand response equipment has been deactivated or
disconnected.
GEAppliances.com
13