Dryer Features; Settings Option - GE Profile DPVH890EJ Owner's Manual And Installation Instructions

About cycle options.
NOTE: Not all features are available on all dryer models.
About dryer features.
Engage the handle posts
10
Settings
Under the SETTINGS option, you can
adjust the volume or the brightness of
the display.
VOLUME
■ End of Cycle (signal) volume can be set
from HIGH, MED, LOW or OFF.
■ Control Sounds volume can be set from
HIGH, MED, LOW or OFF.
Drum Lamp
Before replacing the light bulb, be sure to unplug the dryer power cord or
disconnect the dryer at the household distribution panel by removing the
fuse or switching off the circuit breaker. Reach above dryer opening from
inside the drum. Remove the bulb and replace with the same size bulb.
Built-In Rack Dry System
A handy drying rack may be used for drying items such as tennis shoes.
Place items flat on the drying rack and block such items as wool sweaters
and delicate fabrics. Dry with low heat.
To install the Built-In Rack Dry System
1. Make sure the drum of the dryer is oriented so the rack drying system is
on the left side of the dryer.
2. Pull the drying rack screen out from the left side and engage the handle
"posts" in the opposite baffle slots.
3. Place the garment on the rack and close the door.
4. Press the DRYER RACK button.
5. Select desired TIME.
6. Press the START/PAUSE button.
NOTE:
■ Do not use this drying rack when there are other clothes in the dryer.
■ Make sure to detach the drying rack at the end of the cycle and fully
retract the screen back into the baffle.
DISPLAY BRIGHTNESS can be set from
HIGH, MED or LOW.
After you have made your selection,
press ENTER.