Parts - Truper PRE-1I Manual

• The device complies with the latest safety requirements if
it is used for its intended purpose. The device can only be
used within the allowed performance restrictions.
• It should not be used for pumping drinking water or
irrigating consumables. Do not pump explosive,
flammable, or aggressive materials, harmful substances, or
sewage.
• The device is not suitable for commercial or industrial
use.
• Improper use or modifications to the device, the use of
components that have not been tested and approved by
the manufacturer, can result in unforeseen damage to the
device and the operator, and release the manufacturer
from legal liability.
• Automatic pressure control is used to control the start
and stop of a water pump when opening or closing any
faucet or valve in the system. The control will maintain a
constant pressure and flow of water in the system
whenever any water outlet in the network is open during
the pump's operation.
WARNING The control can be used for both
potable and non-potable water. In installations where both
types of fluids are present, ensure that potable water does
not mix with non-potable water.
Work indicator
lights
Reset button
Junction box
Fan
cover
Mounting
brackets
6
ENGLISH
Pressure water
outlet
Motort
Safety warnings for
using water pumps
CAUTION
not use the device around wet areas.
WARNING
there is a risk of explosion or near flammable liquids or
gases.
WARNING
device or other electrical components. There is a risk of
death due to electric shock.
CAUTION
meet the water feeding the unit.
• Do not install or turn on the unit when there are people
or animals in the water to be pumped (e.g., a pool) or in
contact with it.
• Do not leave the unit unattended. If you must leave it for
an extended period, disconnect it.
• Any repairs must be carried out only by a
Authorized Service Center. Otherwise, you are at risk of
electric shock, and it voids the warranty.
• Do not remove or cover the symbols attached to the
device. Any information on the device that is no longer
legible should be replaced immediately.
• Read and follow the operating instructions before
pumping.
• It is recommended that the pump is powered by a circuit
that includes a residual-current device (RCD) with a rated
current not greater than 30 mA.
Union fitting
Purge cap
Water pump
body
• Do not expose the device to rain. Do
• Do not use the device in areas where
• Do not direct the water stream at the
• Ensure that the extension cord does not

Parts

Starting pressure
adjustment screw
Power
cord
Pump connection
cable
Water
inlet
Drain cap