Changing Channels - Handicare FREECURVE 3 Manual

A
7

CHANGING CHANNELS

1
<50 m
A
B
8
10
[7]You can check the remotes:
first push the red button of the remote and the
B
lift should go down{A}. Push the green button
and the lift should go up{B}.
Changing channel
[8]If there is more than one lift in the range of
the remotes{A} or otherwise interference {B},
you can set the remotes on a different channel.
There are four channels.
A
2
9
A
REMOTE CONTROL RF
B
B
11
Relink the remote controls:
SEE g. 2 - 6
12
REMOTE CONTROL RF SPAREPARTS 2
INSTRUCTION
[9]Remove the blue covers (915 Mhz) or the
green covers (2.4 Ghz) on the backside of the
remotes{A}. Set the dipswitches{B}(note: pay
attention to the position of the word "on"
as this is not always on the same position).
Reinstall the covers{C}. [10]Remove the lower
cap of the receiver board housing{A}. Set the
dipswitch on the board{B}. [11]Reinstall the
cap on the receiver board housing. [12]Relink
the remote controles (see illustration 2-6).
C
4 POSSIBLE POSITIONS
2 of 3
C