Installing Video Ram; Prepare The Computer - Power Computing PowerCenter MT User Manual

Installing video RAM

1. If you are not proÞcient with electronic equipment, Power Computing
CAUTION!
Corporation recommends that you have a certiÞed technician install
expansion cards, RAM, and internal drives. If you attempt to install
expansion cards, RAM, or internal drives yourself, any damage you may
cause to your equipment will not be covered by the limited warranty on
your computer. Please call technical support at 1-800-708-6227 for
additional information about this or any other warranty question.
2. If an anti-static bracelet is available, put it on and ground it to your
computer before touching any components inside the computer.
3. Handle DIMMs by the ends and avoid touching their contacts or other
metal components.
4. Always store DIMMs in static-resistant bags.
5. Take your time; donÕt hurry.

Prepare the computer

1.
If you havenÕt done so, remove the cover from the computer.
See ÒRemoving the coverÓ starting on page 50 for instructions.
Make sure the computer is powered down before removing the cover.
WARNING!
Touch the metal plate over the hard disk drive to discharge any static
CAUTION!
electricity that might have built up on your clothes or body.
The system must be plugged in (see step 1 on page 51) for this to work
Use an anti-static grounding strap and handle memory modules by the
non-metallic edges only.
For Technical Support, Call 1-800-708-6227
All manuals and user guides at all-guides.com
Adding Memory (RAM and Video RAM)
PowerCenter MT UserÕs Guide
.
59