Connecting To Sfp Modules; Connecting To Fiber-Optic Sfp Modules - Cisco ME 3400 Hardware Installation Manual

Chapter 2 Switch Installation
Reconfigure and reboot the connected device, if necessary.
Step 3
Repeat Steps 1 through 3 to connect each device.
Step 4

Connecting to SFP Modules

This section describes how to connect to SFP modules. For instructions on how to connect to fiber-optic
SFP modules, see the
connect to copper 1000BASE-T SFP modules, see the
section.
For instructions about how to install or remove an SFP module, see the
Modules" section on page

Connecting to Fiber-Optic SFP Modules

Follow these steps to connect a fiber-optic cable to an SFP module:
Warning Class 1 laser product. Statement 1008
Caution Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables
from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and cabling stipulations in
the
See
SFP module.
Step 1 Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Insert one end of the fiber-optic cable into the SFP module port (see
Step 2
Figure 2-18
1
Insert the other cable end into a fiber-optic connector on a target device.
Step 3
OL-7677-04
"Connecting to Fiber-Optic SFP Modules"
2-16.
"Installation Guidelines" section on page 2-4
Appendix A, "Connector and Cable Specifications,"
Connecting to a Fiber-Optic SFP Module Port
LC connector
"Connecting to 1000BASE-T SFP Modules"
and in the "SFP Module Ports" section on page
for information about the LC on the
C is co M
E 3 4 0 0
SE RI ES
1
2
Cisco ME 3400 Ethernet Access Switch Hardware Installation Guide
Connecting to SFP Modules
section. For instructions on how to
"Installing and Removing SFP
Figure 2-18).
1-7.
2-21