Setting The Host Name; Setting The Ip Address - Cisco VG248 - Gateway Software Configuration Manual

Chapter 2 Getting Started with the VG248

Setting the Host Name

Step 1
Step 2
Step 3
Step 4
Step 5

Setting the IP Address

Step 1
Step 2
Step 3
Step 4
Step 5
OL-1209-02
The host name identifies each VG248 on your TCP/IP network, enabling you to
access the device using this name rather than the IP address.
By default, this value is set to be the same as the device name registered in the
Cisco CallManager database. This device name is a unique character string
generated based on the MAC address for the VG248 (see the
to Cisco CallManager" section on page 4-2
setting to modify the host name.
To change the host name, perform these steps:
From the main menu, choose Configure.
Choose Network interface.
Choose Host name.
Enter the host name to be used by the VG248.
Restart the VG248.
The IP address identifies each VG248 on your TCP/IP network. You must enter
the IP address if you are not using DHCP. The VG248 automatically obtains an
IP address if you are using DHCP.
To assign an IP address, perform these steps:
From the main menu, choose Configure.
Choose Network interface.
Choose IP address.
Enter the IP address to be used by the VG248.
Restart the VG248.
Cisco VG248 Analog Phone Gateway Software Configuration Guide
Configuring Network Settings
"Adding the VG248
for details). However, you can use this
2-7