Configuring Analog Phones Using Cisco Callmanager; Overview - Cisco VG248 - Gateway Software Configuration Manual

Configuring Analog Phones Using
Cisco CallManager
The VG248 connects to Cisco CallManager to provide access from the analog
phones to Cisco CallManager. To configure the analog phones using
Cisco CallManager, you actually configure the ports on the VG248. The changes
you make to a specific port (such as disabling call waiting or assigning speed
dials) apply directly to the analog device connected to that port.
The following sections provide an overview of the configuration requirements for
Cisco CallManager:
This guide does not contain details about configuring Cisco CallManager. Refer
to the documentation and online help provided with Cisco CallManager for
installation and configuration instructions.

Overview

Cisco CallManager does not recognize the VG248 as a single IP telephony
device. Instead, each of the 48 ports are identified as individual devices, similar
to IP phones.
OL-1209-02
• Overview, page 4-1
• Adding the VG248 to Cisco CallManager, page 4-2
• Configuring the VG248 Analog Ports, page 4-3
Cisco VG248 Analog Phone Gateway Software Configuration Guide
C H A P T E R
4
4-1