Identifying The Directory Number For Clearing Mwi On Cisco Callmanager; Entering A Keep Alive Number; Step 1 From The Main Menu, Choose Configure; Step 2 Choose Smdi - Cisco VG248 - Gateway Software Configuration Manual

Chapter 5 Integrating Cisco CallManager with Voice Mail Systems Using SMDI

Step 1

Step 2
Step 3
Step 4
Identifying the Directory Number for Clearing MWI on
Cisco CallManager
Step 1
Step 2
Step 3
Step 4

Entering a Keep Alive Number

OL-1209-02
From the main menu, choose Configure.
Choose SMDI.
Choose CallManager MWI on DN.
Enter the value that matches the MessageWaitingOnDN parameter in
Cisco CallManager.
If you have enabled the VG248 to forward MWI commands from the voice mail
system to Cisco CallManager, you must identify the directory number used to
clear MWI commands. The value should match the value entered in the
Cisco CallManager MessageWaitingOffDN parameter, which is available by
choosing Service > Service Parameters in Cisco CallManager.
From the main menu, choose Configure.
Choose SMDI.
Choose CallManager MWI off DN.
Enter the value that matches the MessageWaitingOffDN parameter in
Cisco CallManager.
Some voice mail systems use a Keep alive SMDI number to determine whether
or not the SMDI connection is active. The voice mail system sends out a test MWI
operation for this voice mail box number and expects to receive a negative
response from the attached VG248.
You must configure the VG248 with this keep alive number so it distinguishes the
MWI commands on this number from those on a real extension number.
Cisco VG248 Analog Phone Gateway Software Configuration Guide
Configuring SMDI Settings on the VG248
5-27