Cisco SRW224P User Manual page 99

24-port 10/100 + 2-port gigabit switch with webview and power over ethernet
Table of Contents

Advertisement

24-port 10/100 + 2-Port Gigabit Switch with WebView and Power over Ethernet
Safety Compliance
Warning: Fiber Optic Port Safety
When using a fiber optic port, never look at the transmit laser while it is powered on. Also, never look directly at the fiber TX port and fiber cable ends when
CLASS I
LASER DEVICE
they are powered on.
Avertissment: Ports pour fibres optiques - sécurité sur le plan optique
Ne regardez jamais le laser tant qu'il est sous tension. Ne regardez jamais directement le port TX (Transmission) à fibres optiques et les embouts de câbles
DISPOSITIF LASER
DE CLASSE I
à fibres optiques tant qu'ils sont sous tension.
Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit
Niemals ein Übertragungslaser betrachten, während dieses eingeschaltet ist. Niemals direkt auf den Faser-TX-Anschluß und auf die Faserkabelenden
LASERGER
ÄT
DER KLASSE I
schauen, während diese eingeschaltet sind.
Please read the following safety information carefully before installing the switch:
WARNING: Installation and removal of the unit must be carried out by qualified personnel only.
"The unit must be connected to an earthed (grounded) outlet to comply with international safety standards.
"Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection.
"The appliance coupler (the connector to the unit and not the wall plug) must have a configuration for mating with an EN 60320/IEC 320 appliance inlet.
"The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet.
"This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950. The conditions are only maintained if the equipment to which it is connected also
operates under SELV conditions.
France and Peru only
This unit cannot be powered from IT† supplies. If your supplies are of IT type, this unit must be powered by 230 V (2P+T) via an isolation transformer ratio 1:1, with the secondary
connection point labeled Neutral, connected directly to earth (ground).
† Impédance à la terre
91

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents