Pre-Installation Considerations - Cisco SRW224P User Manual

24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet

Pre-Installation Considerations

Fast Ethernet Considerations
If you will be using the Switch for Fast Ethernet (100Mbps) applications, you must observe the following
guidelines:
Full-Duplex
As previously mentioned, the Switch provides full-duplex support for its RJ-45 ports. Full-duplex operation allows
data to be sent and received simultaneously, doubling a port's potential data throughput.
If you will be using the Switch in full-duplex mode, the maximum cable length using Category 5 cable is 328 feet
(100 meters).
Positioning the Switch
Before you choose a location for the Switch, observe the following guidelines:
1. Make sure that the Switch is accessible and that the cables can be connected easily.
2. Keep cabling away from sources of electrical noise, power lines, and fluorescent lighting fixtures.
3. Position the Switch away from water and moisture sources.
4. To ensure adequate air flow around the Switch, be sure to provide a minimum clearance of two inches
(50mm).
5. Do not stack free-standing Switches more than four units high.
6. Connect Network Devices
7
Chapter 3: Connecting the Switch
Pre-Installation Considerations