Figure 5-31: Qos - Rate Limit - Cisco SRW224P User Manual

24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet
Rate Limit
This function allows the network manager to control the maximum rate for traffic transmitted or received on an
interface. Rate limiting is configured on interfaces at the edge of a network to limit traffic coming out of the
switch. Traffic that falls within the rate limit is transmitted, while packets that exceed the acceptable amount of
traffic are dropped.
Rate limiting can be applied to individual ports or lags. When an interface is configured with this feature, the
traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
The rate limit screen displays both Fast Ethernet Granularity and Gigabit Granularity.
Rate limit granularity is an additional feature enabling the network manager greater control over traffic on the
network. The "rate limit granularity" is multiplied by the "rate limit level" to set the actual rate limit for an
interface. Granularity is a global setting that applies to Fast Ethernet or Gigabit Ethernet interfaces.
Use the drop-down menus to change the rate limit for fast ethernet and/or gigabit granularity, click submit.
Set the Input Rate Limit Status or Output Rate Limit Status, then set the rate limit for the individual interfaces, and
click Apply.
To configure input rate limit for each port or lag, click Port Conf or Trunk Conf in the Input row of the table
respectively.
To configure output rate limit for each port or lag, click Port Conf or Trunk Conf in the Output row of the table
respectively.
Rate Limit Configuration
To configure Port Input Rate Limit, click the Enable checkbox and then set the rate limit level in the textfield
provided.
Port Rate Output Limit is configured the same way on the Port Output Rate Limit Configuration screen.
If a port is assigned as a lag member then the rate limit of that port cannot be set in the port configuration
screen.
Truck Rate Limit is configured the same way as port rate limit using the trunk Input and output screens.
Chapter 5: Configuring the Switch through the Web Utility
QoS

Figure 5-31: QoS - Rate Limit

NOTE: When the rate limit granularity is set to a low
value (for 10/100 ports, less than 512 Kbps), the
maximum bandwidth available on ports is restricted to
a value that is "256 x granularity." This restriction also
applies to ports with rate limiting disabled.
49