Figure 5-7: Dynamic Address Screen; Figure 5-8: Static Address Screen - Cisco SRW224P User Manual

24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet
Dynamic Address
The Dynamic Address Table contains the MAC addresses learned by monitoring the source address for traffic
entering the switch. When the destination address for inbound traffic is found in the database, the packets
intended for that address are forwarded directly to the associated port. Otherwise, the traffic is flooded to all
ports.
Interface. Indicates a port or lag.
MAC Address. Physical address associated with this interface.
VLAN. ID of configured VLAN (1-4094).
Address Table Sort Key. You can sort the information displayed based on MAC address, VLAN or interface (port
or lag).
Dynamic Address Counts. The number of addresses dynamically learned.

Figure 5-7: Dynamic Address Screen

Current Dynamic Address Table. Lists all the dynamic addresses.
Specify the search type (that is, check the Interface, MAC Address, and/or VLAN checkbox), select the method of
sorting the displayed addresses, and then click Query.
Static address
A static address can be assigned to a specific interface on this switch. Static addresses are bound to the
assigned interface and will not be moved. When a static address is seen on another interface, the address will be
ignored and will not be written to the address table.
Static Address Counts. The number of manually configured addresses. The Switch allows 8,000 Static Address
Counts.
Current Static Address Table. Lists all the static addresses.
Interface. Port or lag associated with the device assigned a static address.
MAC Address. Physical address of a device mapped to this interface.

Figure 5-8: Static Address Screen

VLAN. ID of configured VLAN (1-4094).
Specify the interface, the MAC address and VLAN, then click Add Static Address.
28
Chapter 5: Configuring the Switch through the Web Utility
System Information