Attaching L Brackets To The Chassis - Cisco ME-C6524GS-8S Installation Manual

Chapter 3 Installing the Switch

Attaching L Brackets to the Chassis

The rack-mount L brackets are included in the accessory kit. The L brackets can be installed either on
the front sides of the chassis or on the rear sides of the chassis.
To install the L brackets on the front sides of the chassis, follow these steps:
Remove the two rack-mount brackets and eight M4 x 8 mm Phillips flat-head screws from the accessory
Step 1
kit.
Note
Position the left L bracket (p/n 700-20931-xx) against the left chassis side, and align the countersunk
Step 2
screw holes. (See
Secure the L bracket to the chassis with four M4 x 8 mm Phillips flat-screws.
Step 3
Step 4 Repeat Steps 2 and 3 for the right L bracket (p/n 700-20932-xx).
Figure 3-1 Installing the Rack-Mount Brackets
CO NS
PS 1
OL E
PS 2
FA N
ST AT
US
o
+
-
OL-8900-03
The L brackets are stamped with different part numbers to identify them as left and right. The
left-side L bracket (as viewed from the front of the chassis) has the part number 700-20931-xx;
the right-side L bracket (as viewed from the front of the chassis) has the part number
700-20932-xx.
Figure 3-1, top view.)
US B
FL AS
H
Front-mounting position
o
+
OU TP UT
INP UT
OK FA N
OK -
OK
OU TP UT
INP UT
OK FA N
OK
OK
Rear-mounting position
Ca ta ly st
65 24 G S
M4 Phillips flat-head screws
M4 Phillips flat-head screws
Cisco ME 6500 Series Ethernet Switch Installation Guide
Rack-Mounting
3-5