Spike 78-3500V-R Installation Instructions

READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION TO
AVOID INJURY TO YOURSELF, DAMAGE TO THE VEHICLE OR ACCESSORY.
• Torque specifications must be followed when tightening bolts. Over-tightening any and/or all screws will
cause cracks around mounting holes which is not covered by any warranty.
• As specified on carton label, once protective film on shields is removed, product cannot be returned.
• As specified on carton label, damage caused by packaging staples is not covered by warranty. All staples must
• ANY cutting, trimming, drilling or altering of this product as delivered is not covered under warranty.
• Failure to follow these installation instructions completely may void any warrantable components and result in
• Do not use Loctite/Super Glue or any other similar fastener adhesive. These types of products react to plastics
• Our windshields are made from the highest quality material providing optimum transparency and clarity.
Blurriness and/or extrusion marks may or may not appear when looking through windshield from a wide,
• The application of improper cleaners, abrasive and/or dirty cleaning towels can severely damage the product.
Failure to follow cleaning recommendation (provided herewith) may void any warrantable components.
These instructions contain important information for future reference and must be given to the customer at time of
ITEM
A
B
C
D Co-extruded bulb seal (¼")
E
INSTRUCTION BAG
F
1. Installation
a) Insert the injected rubber pad spacers (Item E) to all clamps
as shown below.
78-3500V-R - Instructions CFMOTO ZFORCE 950 SPORT Vent Rear Windshield GP - rev00
IMPORTANT NOTICES
• For proper installation, TWO people are required .
be removed prior to removing product from carton.
product damage or personal injury.
and cause cracking. Not covered by any warranty.
side-angle. This is normal for all extruded clear plastic materials.
purchase or upon completion of installation.
Parts List
(parts available with kit only and not available separately)
PART NAME
Rear windshield
Lower center panel
Vent assembly Includes: 1 vent cover, 1 vent flap assembly, 1 rubber vent seal and 7 vent mounting screws
Includes: 45" Co-extruded bulb seal (¼") / #77-95BS [end user to cut to exact length]
Flop clamp set
Includes: 4 Philips truss head screws M6 x 16, 2 Philips truss head screws M6 x 24, 6 plastic shoulder
Nuts & bolts
washers M6, 2 locknuts M6, 2 washers M6 x 25, 2 rubber bushings M8 and 5 push type retainers (
INSTALLATION INSTRUCTIONS
CFMOTO ZFORCE 950 SPORT
VENT REAR WINDSHIELD
PART # 78-3500V-R
DEALER
DESCRIPTION
CNC rear windshield cut-out made of ⅛" thick GE polycarbonate or equivalent
CNC lower center panel cut-out made of ⅛" thick GE polycarbonate or equivalent
Includes: 4 flop clamps and 8 injected rubber pad spacers (1 ¾")
BAD
INSTALLATION
www.spikepowersports.com / 888-769-2295
QTY
1
1
1
1
1
1
5
/ ")
16
GOOD
INSTALLATION
1