G12Sxi Module - Extreme Networks Summit 300-24 Hardware Installation Manual

G12SXi Module

Figure 153 shows the G12SXi module.
Figure 153: G12SXi module
51040
Module status LEDs
1 5 9
Port status LEDs
2 6 10
3 7 11
4 8 12
AMBER = ACTIVITY
GREEN = LINK OK
=
FLASHING GREEN DISABLED
1
2
3
4
5
1000 Mbps
6
ports
7
8
9
10
11
12
The G12SXi module has 12 Gigabit Ethernet ports that use standard MT-RJ connectors, and supports
1000BASE-SX only. The default configuration of the G12SXi module is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in auto-negotiation mode.
LEDs
The G12SXi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the G12SXi module, see "I/O Module LEDs" on
page 293.
Software Requirements
The G12SXi module requires ExtremeWare version 6.1.4 or later.
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
EW_G12SXi
Configuring I/O Modules
269