Configure Wireless Endls-A2+Wigx2 Router Via Html; Login - Encore ENDSL-A2+WIGX2 User Manual

Alternate DNS server: Fill in alternate DNS server IP address.
You can use ping command under DOS prompt to check if you have setup TCP/IP
protocol correctly and if your computer has successfully connected to this router.
2) Type ping 192.168.1.1 under DOS prompt and the following messages will appear:
Pinging 192.168.1.1 with 32 bytes of data:
Reply from 192.168.1.1: bytes=32 times<2ms TTL=64
Reply from 192.168.1.1: bytes=32 times<1ms TTL=64
Reply from 192.168.1.1: bytes=32 times<10ms TTL=64
If the communication link between your computer and router is not setup correctly, after
you type ping 192.168.1.1 under DOS prompt following messages will appear:
Pinging 192.168.1.1 with 32 bytes of data:
Request timed out.
Request timed out.
Request timed out.
This failure might be caused by cable issue or something wrong in configuration procedure.
4. Configure ENDLS-A2+WIGX2 via HTML
This device supports a Web-based (HTML) GUI to allow users to configure Router setting
via Web browser.

4.1 Login

1) Launch the Web browser.
2) Enter the default IP address
3) Entry of the username and password will be displayed. Enter the default login
User Name and Password:
The default login User Name of the administrator is admin, and the default
login password is trendchip.
http://192.168.1.1
26