Shoot-Thru-Hull Installation - Eagle FishEasy 245DS Portable Installation And Operation Instructions Manual

Fish-finding & depth-sounding sonars
Hide thumbs Also See for FishEasy 245DS Portable:
Table of Contents

Advertisement

Shoot-Thru-Hull Installation

1. Make sure the area is clean, dry and free of oil or grease, then sand
both the inside surface of the hull and the face of the transducer with
100 grit sandpaper. The sanded hull area should be about 1-1/2 times
the diameter of the transducer. The surface of the hull must be flat so
the entire transducer face is in contact with the hull prior to bonding.
After sanding, clean the hull and transducer with rubbing alcohol to
remove any sanding debris.
Sand this surface
Orient the Skimmer
with the nose facing
the bow of the boat.
WARNING:
Use only the epoxy available from LEI. It has been for-
mulated to work with these installation procedures.
Other epoxy types may be too thin or may not cure to
the right consistency for optimum transducer perform-
ance.
To bow
Epoxy transducer to hull.
Spread epoxy here
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents