Verifying The Front Panel Led Indications; Verifying The Hardware Configuration; Configuring The Router - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Chapter 5 Power-Up and Initial Configuration Procedures

Verifying the Front Panel LED Indications

The front-panel indicator LEDs described in
useful during power up. For more detailed information about the LEDs, see the
on page
Table 5-1 LED Indicators for the Cisco 1800 Series Fixed-Configuration Router
LED Label LED Color or State
SYS OK Solid green
Blinking green
Off
1
POE Green
Amber
Off
CF Blinking green or solid green
Off
1. Inline power is a field-upgradable option on Cisco 1800 series fixed-configuration routers; inline power is not installed by default.

Verifying the Hardware Configuration

To display and verify the hardware features, enter the following commands:
•
•

Configuring the Router

This section includes the following topics:
•
•
•
•
OL-6425-03
To use the CLI to configure the router, see the
Configuration" section on page
Note If the prompt appears, your system has booted in ROM monitor mode.
rommon 1>
1-4.
Meaning
System is operating normally
System is booting or is in ROM monitor mode
Power is off, or there is a power fault
Inline power supply is installed and operating normally
Inline power supply fault
Inline power supply is not installed
CompactFlash memory is being accessed; do not eject
CompactFlash memory is not being accessed; OK to eject
show version—Displays the system hardware version; the installed software version; the names and
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and
flash memory.
show diag—Lists and displays diagnostic information about the controllers and interface
processors.
Initial Configuration Using Cisco Router and Security Device Manager
Initial Configuration Using the Setup Command Facility
Initial Configuration Using the Cisco CLI—Manual Configuration
Verifying the Initial Configuration
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
"Initial Configuration Using the Cisco CLI—Manual
5-7.
Table 5-1 provide power, activity, and status information
Configuring the Router
"LED Indicators" section
5-3