Connecting Routers To Ac Power; Connecting Wan And Lan Cables - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Connecting WAN and LAN Cables

Note The installation must comply with all required electrical codes applicable at the installation site.

Connecting Routers to AC Power

Connect your router to a 15A, 120-VAC (10A, 240-VAC) circuit with overcurrent protection.
Note The input voltage tolerance limits for AC power are 90 and 264 VAC.
Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
15A, 120VAC (10A, 240VAC). Statement 1005
This equipment has been designed for connection to TN and IT power systems. Statement 1007
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
Connecting WAN and LAN Cables
This section describes how to connect the WAN, LAN, and voice interface cables. It covers the
following topics:
•
•
•
Ethernet cables and transceivers can be ordered from Cisco Systems. For ordering information, contact
Note
customer service. For cable pinouts, refer to the
document.
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
4-2
Preparing to Connect to a Network, page 4-3
Ports and Cabling, page 4-4
Connection Procedures and Precautions, page 4-5
Chapter 4 Power, Cable, and Antenna Connection Procedures
Cisco Modular Access Router Cable Specifications
OL-6425-03