Cisco ASR1002 - ASR 1002 Router Quick Start Manual page 25

GigabitEthernet0/0/2
GigabitEthernet0/0/3
GigabitEthernet0
Configuring global parameters:
Enter host name [Router]:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: test
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: tests
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: test
Configure SNMP Network Management? [yes]: n
Configure IP? [yes]: y
Configure RIP routing? [no]:
Configure bridging? [no]:
Configure CLNS? [no]:
Configuring interface parameters:
Do you want to configure GigabitEthernet0/0/0
Do you want to configure GigabitEthernet0/0/1
Do you want to configure GigabitEthernet0/0/2
Do you want to configure GigabitEthernet0/0/3
Do you want to configure GigabitEthernet0
The following configuration command script was created:
hostname Router
enable secret 5 $1$6r./$U5wHcV3uRWkKWK/fap474.
enable password tests
line vty 0 4
password test
no snmp-server
!
ip routing
no bridge 1
no clns routing
!
interface GigabitEthernet0/0/0
shutdown
no ip address
!
interface GigabitEthernet0/0/1
shutdown
no ip address
!
.
.
.
end
unassigned NO unset
unassigned NO unset
unassigned YES unset
interface? [no]: n
down
down
administratively down down
interface? [yes]: n
interface? [yes]: n
interface? [yes]: n
interface? [yes]: n
down
down
25