Cisco ASR1002 - ASR 1002 Router Quick Start Manual page 20

Verify Power Supply Operation
Follow this procedure to verify the power supplies are operating correctly.
Check that the power supply LEDs are illuminated as follows:
Step 1
INPUT OK LED is green.
–
FAN OK LED is green.
–
OUTPUT FAILED LED is not illuminated.
–
Step 2 To ensure that the power supply is running, enter the show platform command. This output sample is from a
Cisco ASR 1002-F Router.
#show platform
Chassis type: ASR1002-F
The following is a sample output display:
Slot Type
1 ASR1000-SIP10
1/1 SPA-8X1GE-V2
2 ASR1000-SIP10
2/0 SPA-1X10GE-L-V2 ok
2/1 SPA-8X1GE-V2
R0 ASR1000-RP1
F0 ASR1000-ESP10
P0 ASR1002-PWR-AC
P1 ASR1002-PWR-AC
Slot CPLD Version
1 07091401
2 07091401
R0 08060301
F0 08041102
If the LEDs indicate a power problem or the power supply state shows "ps,fail", then contact a customer service
Note
representative for assistance or additional instructions.
Start the Cisco ASR 1002-F Router
Check the following conditions before you start the Cisco ASR 1002-F Router:
• The Cisco ASR 1002-F Router has one slot for the Cisco ASR1002-SIP10-F. Make certain that the SPA is firmly seated in
its subslot and its captive installation screws are securely tightened.
Note The ASR 1002-F Router has only one half-height removable SPA.
• The integrated Cisco ASR1002-ESP-F forwarding processor in the Cisco ASR 1002-F Router is secured and its captive
screws are securely tightened.
• All network interface cables are connected.
• The console terminal is turned on.
20
State Insert Time
ok 00:03:19
ok 00:02:23
ok 00:03:19
00:02:22
ok 00:02:17
ok,active 00:03:19
ok,active 00:03:19
ok 00:02:50
ps, fail 00:02:50
Firmware
Version
12.2(33r)XN2
12.2(33r)XN2
12.2(0:0)
12.2(33r)XN2