Recovering A Lost Password; Determining The Configuration Register Value - Cisco 1760 - VPN Bundle Router Hardware Installation Manual

Recovering a Lost Password

Recovering a Lost Password
Note

Determining the Configuration Register Value

Step 1
Step 2
Step 3
Cisco 1760 Modular Access Router Hardware Installation Guide
3-2
This section describes how to recover a lost enable password and how to enter a
new enable secret password.
Password recovery consists of the following major processes:
Determining the Configuration Register Value
•
With this process, you determine the configuration of the router, so that you
may restore the configuration after the password is recovered.
Resetting the Router
•
With this process, you reconfigure the router to its intial startup
configuration. You then display the enable password, if one is used.
Resetting the Password
•
If you are using an enable secret password, you enter a new password with
this process. You then restore the router to its prior configuration.
Resetting the Configuration Register Value
•
If you are using an enable password, you use this process to restore the router
to its prior configuration.
See the "Hot Tips" section on Cisco.com for additional information on replacing
enable secret passwords.
Follow these steps to determine the configuration register value:
Connect an ASCII terminal or a PC running a terminal-emulation program to the
console port on the router. See the
"Installation."
Configure the terminal to operate at 9600 baud, 8 data bits, no parity, 1 stop bit
and no flow control.
Reboot the router by pressing the power switch to the off ( 0 ) position and then
to the on ( | ) position.
Chapter 3
"Connecting a PC" section in Chapter 2,
Troubleshooting
78-13342-03