Cisco 1605-R How To Use Manual page 54

1-Port ISDN BRI Cards
Figure 3-4
Serial transition
Step 4
Step 5
If you have additional cards to install, proceed to the appropriate section(s) in this manual.
When you have finished all installations, see the software configuration guide that shipped
with your hardware.
1-Port ISDN BRI Cards
This section describes the following Cisco ISDN BRI WAN interface cards:
•
1-Port BRI S/T WAN Cards (WIC36-1B-S/T, WIC-1B-S/T) on page 3-7
•
1-Port BRI with NT1 WAN Cards (WIC36-1B-U, WIC-1B-U) on page 3-7
3-6 Cisco WAN Interface Cards Hardware Installation Guide
Connecting the Serial WAN Port to a Modem or DSU/CSU
Synchronous serial
port (DB-60)
CONN LED
cable
EIA/TIA-232, EIA/TIA-449, V.35,
X.21, or EIA-530 connector
Turn ON power to the router by pressing the power switch to the ON ( | )
position.
Check that the CONN LED goes on, which indicates that the card's serial port
detects the WAN serial connection.
CON N
SERI AL
CSU/DSU or
other DCE