WAN Interface Cards
WAN Interface Cards
On the Cisco 1601 through Cisco 1604, you can use the WAN interface card connection as
a secondary WAN connection, which can be used if the router on-board WAN connection
fails. On the Cisco 1605, you can choose the type of WAN connection that you want for
your network.
For more information about the cards, including function, installation, and configuration,
refer to the Cisco WAN Interface Cards Hardware Installation Guide document that comes
with the card. You received this document if you ordered a WAN interface card.
Rear-Panel Connectors
Figure 1-2 through Figure 1-6 illustrate the connectors for each of the five router models.
Figure 1-2
Cisco 1601 Rear Panel
10 BASE T
ETHERNET Ø
LNK
Figure 1-3
Cisco 1602 Rear Panel
ETHERNET Ø
10 BASE T
LNK
1-4
Cisco 1600 Series Router Hardware Installation Guide
AUI
SERIAL Ø
RDY
AUI
SERIAL Ø 56K DSU/CSU
CARRIER
ALARM
LOOPBACK
DO NOT INSTALL ANY WAN
MODULE WITH POWER ON
CONSOLE
WIC
OK
FLASH PC CARD
DO NOT INSTALL ANY WAN
MODULE WITH POWER ON
CONSOLE
WIC
OK
FLASH PC CARD
14 VDC
14 VDC