Cisco 1603R User Manual page 24

Connecting the Router to the LAN
Connecting to a 10BaseT Ethernet
You must supply an Ethernet hub and an RJ-45-to-RJ-45 cable for this connection. Follow
these steps to connect the router to a 10BaseT Ethernet LAN:
Step 1
Step 2
Step 3
Figure 2-3 10BaseT Port to Ethernet Hub Connection (Cisco 1601 Shown)
10BaseT port
AU I
Straight-through
Ethernet cable
2-6 Cisco 1600 Series Router Hardware Installation Guide
Connect one end of the Ethernet cable to the 10BASE T port.
Connect the other end of the cable to one of the ports on the 10BaseT hub.
Check the following LEDs:
•
LNK LED (rear panel, next to 10BaseT port)—On when the router is
correctly connected to the 10BaseT Ethernet LAN.
•
LAN ACT LED (front panel)—On when there is traffic on the Ethernet LAN.
L N K
10BaseT link LED
8
7
1
W IC
D O N
O T IN
ST A LL
M O D
U LE
A N Y
W IT H W A N
PO W
ER O
N
O K
O K
10BaseT hub