Cisco 1603R User Manual page 20

Connecting Power and Turning On the Router
Caution
10 pounds (4.5 kg). Excessive weight on top of the router could damage the
chassis.
Warning
periods of lightning activity.
Connecting Power and Turning On the Router
If you turn on the router before making network connections, you can verify your
installation by checking the appropriate LEDs during the installation process.
Warning
Warning
(overcurrent) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase conductors
(all current-carrying conductors).
Warning
connected to earth ground during normal use.
Follow these steps to connect the router to power and turn it on:
Step 1
Step 2
Step 3
Step 4
Step 5
2-2 Cisco 1600 Series Router Hardware Installation Guide
Do not place anything on top of the router that weighs more than
Do not work on the system or connect or disconnect cables during
The power supply is designed to work with TN power systems.
This product relies on the building's installation for short-circuit
This equipment is intended to be grounded. Ensure that the host is
Connect the DC power cable (included with the router) from the power supply
to the DC power input on the rear panel of the router.
Connect the male end of the power cable to the power outlet.
Connect the female end of the cable to the male receptacle on the power supply.
On the rear panel of the router, turn ON the power by setting the switch labeled
| / O to the | position.
Slip the wire clip over the power cord to ensure that the power cord remains
attached to the router, as shown in Figure 2-1.