Table of Contents
Advertisement
TRENDnet User's Guide
Windows XP
1. Click Start
and then click Control Panel.
2. In the Control Panel window, click on Network Connections.
3. Under Network Tasks on the left panel, click on Create a new connection.
4. In the New Connection Wizard window, click Next.
5. In the window, click on Connect to the network at my workplace and then click Next.
6. In the window, click on Virtual Private Network connection and then click Next.
7. In the Connection Name window, click Next.
8. Next to Host name or IP address, enter the remote router WAN (Internet) IP address
and then click Next.
© Copyright 2012 TRENDnet. All Rights Reserved.
9. In the Completing the New Connection Wizard window, click Finish.
10. Enter the user name and password account information you configured in your
router and check Save this user name and password for the following users: Me only to
save the credentials. Click Connect.
8. Your computer will attempt to connect to the PPTP VPN server (router) and if
successful, you receive a message that indicates that you are connected.
10. To verify connectivity, you can use the ping connectivity test. Click Start
+ R key at the same time to bring up the run command window. Type cmd in the run
command window and click OK. In the command prompt, type ping <IP address> of
remote computer or device over the VPN. If you receive replies, the connectivity is
successful. If you receive time outs, there may problems with IP configuration or
firewall/security settings of the remote computer or device you are trying to
communicate.
TW100-BRV214
75
Advertisement
Table of Contents
