Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for auto maskin Marine Pro
Summary of Contents for auto maskin Marine Pro
- Page 1 Manual# 1140106 Installation Guide AK-6 Analog Expansion MK-6/14 Relay Expansion...
- Page 2 Quick Installation Guide AK-6 Analog Expansion (Marine Plus) MK-6 and MK-14 (Marine Pro and Plus) Date September 2024 Revision www.auto-maskin.com Page ii Quick Installation Guide...
- Page 3 Copyright © 2010 - 2024 by Auto-Maskin AS. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Auto-Maskin AS. Quick Installation Guide Page iii...
- Page 4 Page iv Quick Installation Guide...
- Page 5 Table of Content DOCUMENT INFORMATION ........ 1 ..........1 BOUT THIS MANUAL Responsibilities ..........1 AK-6 ANALOG EXPANSION ........2 ............2 NTRODUCTION ............2 NWRAPPING ............2 NSTALLATION MK-6 AND MK-14 ..........4 ............4 NTRODUCTION ............4 NWRAPPING ............
-
Page 7: About This Manual
For updated information, please Document contact your local distributor. Information About this manual This manual has been published primarily for professionals and qualified personnel. The user of this material is assumed to have basic knowledge in marine systems, and must be able to carry out related electrical work. -
Page 8: Installation
The maximum cable length is 2.0 AK-6 Analog meters. Expansion Installation Introduction Power Off Start by powering off the DCU 305 The AK-6 is an analog expansion completely. module for the DCU 305 series of diesel engine control panels. When connected, it increases the number of Connect the cable For the cable to reach, the AK-6 must... - Page 9 RK-66 terminals AK-6 terminals +24 V 4-20 +24 V 4-20 screen RK-66 Note! Without an AK-6, the wiring for channel 5 is on the RK-66, terminals 27 and 28. With an AK-6, channel 5 wiring shall be moved to AK-6, terminals 1 and 2. Observe that channels 1-5 are presented on the panel page 1, whereas channels 6-11 are presented...
- Page 10 The maximum cable length is 2.0 MK-6 and MK-14 meters. Introduction Installation The MK-6 and the MK-14 are relay Power Off expansion modules. Start by powering off the DCU 305. The relay function is configured in the Rudolf configuration software. Connect the cable Connect the 15-pin DSUB cable Unwrapping...
- Page 11 Configuration Configure the function for each relay in the Rudolf configuration software. Quick Installation Guide Page 5...
Need help?
Do you have a question about the Marine Pro and is the answer not in the manual?
Questions and answers