Table of Contents
Advertisement
Powering the TEW-676APBO
1. Connect one end of an Ethernet cable into the TEW-676APBO (See Connecting the Ethernet
Cable).
2. Connect the opposite end of the Ethernet cable to the P+DATA OUT port on the Power over
Ethernet Injector.
3. Connect one end of another Ethernet cable to the DATA IN port on the Power over Ethernet
Injector.
DATA IN
4. Connect the opposite end of the Ethernet cable to a LAN port on your network.
5. Connect the power cord into the Power over Ethernet Injector. Then connect the power cord into a
power outlet.
6. Verify that the following panel lights are on: LAN, WLAN and PWR.
P+DATA OUT
3
Advertisement
Table of Contents
