Advanced - TRENDnet TEW-670AP User Manual

Set Security: WDS Security depends on your AP security settings. Note: it does not support
mixed mode such as WPA-PSK/WPA2-PSK Mixed mode.

Advanced

This tab allows you to set the advanced wireless options. The options included are
Authentication Type, Fragment Threshold, RTS Threshold, Beacon Interval, and Preamble
Type. You should not change these parameters unless you know what effect the changes will
have on the router.
Fragment Threshold: This specifies the maximum size of a packet during the fragmentation
of data to be transmitted. If you set this value too low, it will result in bad performance.
RTS Threshold: When the packet size is smaller than the RTS threshold, the wireless router
will not use the RTS/CTS mechanism to send this packet.
Beacon Interval: is the interval of time that this wireless router broadcasts a beacon. A
Beacon is used to synchronize the wireless network.
DTIM Period: Enter a value between 1 and 255 for the Delivery Traffic Indication Message
(DTIM). A DTIM is a countdown informing clients of the next window for listening to broadcast
and multicast messages
Data Rate: The "Data Rate" is the rate that this access point uses to transmit data packets. The
access point will use the highest possible selected transmission rate to transmit the data
packets.
N Data Rate: The "Data Rate" is the rate that this access point uses to transmit data packets
for N compliant wireless nodes. Highest to lowest data rate can be fixed.
16