Appendix E Command Line Interface; Overview; Command Reference - TRENDnet TEW-636APB User Manual

Appendix E
Command Line Interface

Overview

If desired, the Command Line Interface (CLI) can be used for configuration. This creates the
possibility of creating scripts to perform common configuration changes. The CLI requires a
Telnet connection to the Wireless Access Point.
Using the CLI - Telnet
1. Start your Telnet client, and establish a connection to the Access Point.
e.g.
Telnet 192.168.0.228
2. You will be prompted for the user name and password. Enter the same login name and
password as used for the HTTP (Web) interface.
The default values are admin for the User Name, and password for the Password.
3. Once connected, you can use any of the commands listed in the following Command
Reference.

Command Reference

The following commands are available.
config vap
?
help
get 11nampdu
get 11namsdu
get 11nguardinterval
get 11nsubchannel
get 11nradioband
get 802.11d
get acctserver
get acctport
get acctsecret
get acl
get active
get aging
get authentication
get beaconinterval
Config Virtual AP X
Display CLI Command List
Display CLI Command List
Set 11n A-MPDU Aggregation Mode
Set 11n A-MSDU Aggregation Mode
Set 11n Guard Interval Mode
Set 11n Extension Sub-Channel
Set 11n Radio Band
Display 802.11d Mode
Display Accounting Server
Display Accounting Port
Display Accounting Secret
Display Access Control Status
Display VAP Active (up) Mode
Display Idle Timeout Interval
Display Authentication Type of WEP
Display Beacon Interval
E
93