Table of Contents
Advertisement
Operation Mode
PTP Bridge AP
MAC Address
Set PTMP APs
Parameters
Channel No
Current Channel
No
11n Parameters
Channel Band-
width
Extension Sub-
Channel
Select the desired mode:
•
Access Point - operate as a normal Access Point
•
Bridge (Point-to-Point) - Bridge to a single AP. You must pro-
vide the MAC address of the other AP in the PTP Bridge AP MAC
Address field.
•
Bridge (Multi-Point) - Select this only if this AP is the "Master"
for a group of Bridge-mode APs. The other Bridge-mode APs must
be set to Point-to-Point Bridge mode, using this AP's MAC ad-
dress. They then send all traffic to this "Master".
•
Bridge (Point-to-Point) + Access Point - act as a Bridge (Point-
to-Point) and Access Point.
•
Bridge (Multi-Point) + Access Point - act as a Bridge (Multi-
Point) and Access Point.
If required, you can specify the MAC addresses of the APs which are
allowed to connect to this AP. To specify the allowed APs:
1.
Click the button "Set PTMP APs".
2.
On the resulting sub-screen, enter the MAC addresses of the
allowed APs.
This is not required unless the Bridge Mode is "Point-to-Point Bridge
(PTP)". In this case, you must enter the MAC address of the other AP
in this field.
Use this to open a sub-window where you can specify the MAC ad-
dresses of the APs which are allowed to connect to this AP.
If "Automatic" is selected, the Access Point will select the best availa-
ble Channel.
If you experience interference (shown by lost connections and/or slow
data transfers) you may need to experiment with manually setting
different channels to see which is the best.
This displays the current channel used by the Access Point.
Select the desired bandwidth from the list.
Select the desired option from the drop-down list.
Access Point Setup
17
Advertisement
Table of Contents
